Novatech's New Donut Loadcell.
Standard Ranges 1, 2, 4, 8, 10, 12, 16 and 20tonne
(10 to 200kN). Low profile with centre hole. Ranges
to suit bolt sizes from M6 to M36. Stainless steel construction.
Tensile applications are ‘fail-safe’. Standard 2 year warranty.
Geometry : Axial strain cylinder in weather sealed case, with
raised end load bearing faces and hole right through. For use in
compression or in fail-safe tensile applications on a wide range
of OEM or end-user applications. The F313 is ideally suited to
engineering force measurements.
It is designed for easy installation, usually between two flat faces
bearing on its loading rings, either unattached or with retaining
spigots positioned in the centre hole. Alternatively tensile load
transfer can be achieved via a tie rod assembly through the
centre hole. In this way the loadcell can indirectly measure
tensile loads in a "fail-safe" mode.
We are happy to design variants of this loadcell to meet your specific
requirements. Versions can be manufactured for fully compensated
operation up to +250°C.
_____________________________________________
February 2003
